Hobgoblin device
- WhoAmI
- 123
- Log files
Hobgoblin_<address>.bin
Use the Harp device pattern to initialize the device, log data, and send commands to and receive messages from the Hobgoblin device.
Registers
The core registers implemented by every Harp device, such as WhoAmI and OperationControl, are described in the Device Registers and Operation specification.
| Name | Address | Type | Access | DefaultĀ [range] | Description |
|---|---|---|---|---|---|
DigitalInputState |
32 | U8 | Event | Reflects the state of the digital input lines. | |
DigitalOutputSet |
33 | U8 | Write, Event | Sets the specified output lines and reports each pulse start. Setting a line stops its pulse train. | |
DigitalOutputClear |
34 | U8 | Write | Clears the specified output lines. Clearing a line stops its pulse train. | |
DigitalOutputToggle |
35 | U8 | Write | Toggles the specified output lines. Toggling a line stops its pulse train. | |
DigitalOutputState |
36 | U8 | Write | Writes the state of all output lines. Writing the state stops every pulse train. | |
AnalogData |
37 | U16[3] | Event | Reports the sampled analog signal on each of the ADC input channels. The ADC is capped at 12 bits of resolution. | |
PulseTrainGP15 |
38 | U32[3] | Write, Event | Starts a pulse train on digital output GP15, or stops it if the pulse width is zero. | |
PulseTrainGP16 |
39 | U32[3] | Write, Event | Starts a pulse train on digital output GP16, or stops it if the pulse width is zero. | |
PulseTrainGP17 |
40 | U32[3] | Write, Event | Starts a pulse train on digital output GP17, or stops it if the pulse width is zero. | |
PulseTrainGP18 |
41 | U32[3] | Write, Event | Starts a pulse train on digital output GP18, or stops it if the pulse width is zero. | |
PulseTrainGP19 |
42 | U32[3] | Write, Event | Starts a pulse train on digital output GP19, or stops it if the pulse width is zero. | |
PulseTrainGP20 |
43 | U32[3] | Write, Event | Starts a pulse train on digital output GP20, or stops it if the pulse width is zero. | |
PulseTrainGP21 |
44 | U32[3] | Write, Event | Starts a pulse train on digital output GP21, or stops it if the pulse width is zero. | |
PulseTrainGP22 |
45 | U32[3] | Write, Event | Starts a pulse train on digital output GP22, or stops it if the pulse width is zero. | |
PulseEventEnable |
46 | U8 | Write | 255 | Specifies the digital output lines whose pulse trains report the start of each pulse on DigitalOutputSet. |